DC Audio
DC Audio 5.0k - 5,000w Monoblock Amplifier
- SKU:
- DCA-AMP-5.0K
- Shipping:
- Calculated at Checkout
Description
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator
• Dual 0 awg power and ground inputs (both must be used)
We recommend for installation
• 1 upgraded battery under the hood
• 1 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear battery
• Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp
• Upgraded aftermarket alternator
• Dash mounted voltage meter
| Features | Voltage | 5.0kw | |
| Output Power (RMS) | 4 ohm | 14.4V | 900Wx1 |
| 2 ohm | 14.4V | 2,300x1 | |
| 1 ohm | 14.4V | 5,000Wx1 | |
| 1 ohm | 16V | 6,000Wx1 | |
| 1 ohm | 18V | 7,300Wx1 | |
| Input Sensitivity | 6V~0.2V | ||
| Low Pass Filter | Switchable | ||
| ( @ 24 dB Slope) | Variable | Hz | 35~250 |
| Subsonic Filter | Switchable | ||
| ( @ 24 dB Slope) | Variable | Hz | 10~50 |
| Bass Boost | Variable | dB | 0-9dB |
| Frequency Response | Hz | 15-270 | |
| Signal to Noise Ratio | dB | 100 | |
| Damping factor | 150< | ||
| Efficiency @ 4ohm | % | Over 90% | |
| THD @ 4ohms | Less than 0.1% | ||
| Fuse Rating | 500 Amps | ||
| Linked Fuse Rating | 1,000 Amps | ||
| Indicator | Power | Yes | |
| Protection | Yes | ||
| Clip | Yes | ||
| Speaker & Power terminal | Mold Type | Yes | |
| Power | Gauge | 0Ga | |
| Heatsink Length | 25.59" (650mm) | ||
| Heatsink Width | 9.38" (238mm) | ||
| Heatsink Height | 2.35" (59.6mm) | ||
Related Products
Related Products
DC Audio 10.0k - 10,000w Monoblock Amplifier
DC Audio
$2,639.99
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Triple 0 awg power and ground inputs
We recommend for...
DC Audio 7.5k - 7,500w Monoblock Amplifier
DC Audio
$2,089.99
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Dual 0 awg power and ground inputs (both must be used)
We recommend...
DC Audio 9.0k - 9,000w Monoblock Amplifier
DC Audio
$2,529.95
Features
Voltage
9.0k
Output Power (RMS)
4 Ω
14.4 VDC
2,400W x 1
2 Ω
14.4 VDC
4,800W x 1
1 Ω
14.4 VDC
9,000
DC Audio 2.0k - 2,000w Monoblock Amplifier
DC Audio
$674.99
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator
We recommend for installation
• 1 upgraded battery...
DC Audio A3 1.2kw Monoblock Subwoofer Amplifier
DC Audio
$424.99
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
We recommend for installation
• 1 upgraded battery under the hood
• Dash...
DC Audio A3 3.5kw Monoblock Subwoofer Amplifier
DC Audio
$1,000.00
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator
We recommend for installation
• 1 upgraded battery...
SoundQubed Q1-2200.2 Monoblock Amplifier
SoundQubed
$620.00
Disclaimer: This amplifier will require an additional charging system to run efficiently. It will run without the additional charging system but you run the risk of damaging the amplifier and/or...
Out of stock
SoundQubed S1-1250 Monoblock Amplifier
SoundQubed
$259.95
The S1-1250 is a class D mono amp boasting a phenomenal load of almost 1500 watts on 1 ohm at 16 volts. It can drive any two SoundQubed HDS2.2 Series Subwoofers, or any one HDS3...
SoundQubed Q1-6000 Monoblock Amplifier
SoundQubed
$1,199.95
Serious Bass for Serious Systems
You asked for more power. Here it is in a 6000W monoblock!
If you need dominating bass, uncompromising power, and the ability to crush it in the lanes, this is the...